Review on 🧲 Silicone Holder with Neodymium Magnet Coating by Fred Meeks

Magnets come with two sets of screws, one set for 1/4" hole plates and one set for 1/8" hole plates. The magnets are strong, but not insanely strong. I could safely set up a 12 ounce hammer with a magnet, but not a 15 ounce hammer. However, being too strong can be a problem. When I tried to remove the square I installed I managed to get the magnet right out of the pegboard. This is really more of a quality issue with my breadboard than the magnet. If this happens again I'll have to think about screwing them on, but I've since learned to push the square out a bit so the magnet surface isn't completely covered before pulling the square out. I find these magnets very handy for solving many problems attaching objects that don't fit standard pegboard accessories. I plan to buy at least one more set.