Review on Socket Organizer Tray Set for Toolboxes - 6PCS Red SAE & Black Metric Socket Storage Trays, Deep and Shadow Socket Holders for 1/4-Inch, 3/8-Inch & 1/2-Inch Drive by Kenny Rossi

So I see a lot of feedback about people flipping sockets and reporting problems. I'm here to tell you that it doesn't matter, some sockets do NOT ALL fit, but in my case it's a small percentage. You need to look at your outlets. Look down at the drive end, if you only see a square hole you are in good shape BUT if your head has a square hole (where the ratchet attaches and then at the end of the square hole you will see a smaller circle. Your Head May not fit if its size is under about 3/8 I've had this problem on a few and it didn't seem to matter what brand I had bushings...it wasn't that there wasn't enough space between the bushings, it was that in some cases the pin was too big to fit through the sockets where they have an extra molding on the bottom of the drive socket All six trays I probably only had 4-5 heads that didn't quite fit. I will also say my 1/2 punch heads are cheap brands (resilient) and not really strong walls but they all fit with no problem but they are close to a friend my artisanal flat 1/2 Clock also fit All the problems I had with the thin-walled chrome came to an end. I seem to remember that all of my homemade sockets fit without any problems. Hope that helps.