Review on Upgrade Your Ram With MODIFY STREET AlphaRex Black LED Projector Headlights: Perfect Fit For 09-18 Ram 1500/10-18 Ram 2500/3500 Models by Joe Unruh

As most will know when putting LED or any type of upgrade with lights you can run into issues with Hyperflashing . Got all installed and worked fine then Driver Side started to have issues and would just stop blinking while inside turn signal was going as fast as it could. Spoke with the guys at Modify and they were more then helpful in providing suggestions as well as wanting to make sure the product was good.1. Easy to install straightforward2. Yes I took the Halogen Low Beam out and put in some LED - Nice. Fit good and easy to swap out.3. Yes Hyeprflashing only happened on Driver Side and only when Engine was running - Rest of time Turn Signal worked just fine.4. Do not use the LED resistors you get and the local part store unless they are 50 w and 6 ohm, not 12v 6 ohm , not 25 W 6 ohm. They will not cut it and you will get frustrated - So do yourselves a favor and get the proper resistors for your set up . I did not need to place a resistor on the Passenger side at all.As you can tell adding LED really lit these babies up. Not bad at all and adding LED to the Fog lights was just a nice addition. No I have never done a review but these guys want to make sure you get what you need or at least help you understand more on what it is happening. So Kuddos to them for understanding Customer Service and being as courteous and helpful as possible, you can find them on facebook and message them when you get in a jam on your install .