Review on 💎 Superior SE 30-Piece Diamond Burrs Set with 150 Grit - High Quality Assorted 8230DD15 by Mike Pfettscher

So here is my story. I was working on a project that I needed to drill and cut - a 6-32 tap - and I broke the faucet. Not only that, I broke the faucet in a hole deep enough that I couldn't turn it back on. I read about different ways to remove it - and nothing helped. The part was too small and the steel too hard. Then I read that someone recommends using a diamond drill bit on a Dremel. I picked up these guys and it completely saved my bacon. It took about 30 minutes to drill through high carbon steel (only this drill could cut through steel - all other drills I used did nothing) before cutting to the bottom of the faucet. The rest of the parts just fell out.