Review on 🔌 10 Pack 4 Pin LED Connector for Waterproof 10mm RGB 5050 5630 LED Strip Lights - Quick Wire Connection, No Need to Strip Wire - SUPERNIGHT by James Ramirez

They are difficult to use. I work with electronics for cars and machines, so I'm pretty good at wiring. It is important to follow the directions to the tee. (Instructions are in the pictures next to the product description. Here are the key points to remember: Make sure you are using the correct indoor or outdoor connectors. You cannot mix the indoor connectors with the outer light band or vice versa. Be Be sure to cut exactly along the line (too short or too long past the line and you won't be able to make a good connection) Be sure to remove the sticky backing before using the connector (this will result in a bad connection; in In my case I lost connection To the green wire so I couldn't do all my colors: As for your note, the metal terminal of the connector slides through the paper from below to make contact, so if you leave the paper there they might touch not). , it will not always be possible to make full contact with the clamps. I noticed where you put a w enig need to adjust tub spacing forward or backward sometimes. I ended up having to connect and record multiple times to adjust the distance and connection before I got it right. There is no room for error, it must be perfectly crimped. If I have anything to add later I will edit my review.