Review on Efficient Power Distribution For Auto, RV, Motorcycle, And Boat With InstallGear 0/2/4 AWG Gauge Power Distribution Block by Tommie Lawson

I used the 1/0 gauge wires and two 1/0awg to 4awg distributions blocks to relocate my battery. The only problem I had was the cable going to the starter was 2awg and the outlets for the block was 4awg. I did not want to use a reducer because I wanted a clean look so I took the block and drilled out one hole to gauge it up. The material was quite soft making the cut very easy and clean. Unless you pulled the wire you would not know the difference.The only thing I would complain about if I was to nick pick, is the backing plate screws protrude through the bottom holes. If you have a tight fit you will need to back these out a little and then retighten after the wire is in. For me, this was no problem.