Review on Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5) by Jimmy Montalvo
Barb is too small for 5/8 hose.
The barbs are too small for 5/8 hose, the smallest diameter of the barb should be 5/8 and the barb should be greater than 5/8. These have the largest diameter of the barb at 5/8 The barb does not bite into the hose and a clamp will not seal it any better than a strait piece of 5/8 pipe or tube.Net result is the fitting leaks.
- Working Temperature
- May not be suitable for high-pressure applications
New products
Comments (0)
Top products in π§ Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
1/2" Hose Barb Beduan 3 Way Shut Off Brass Y Shaped Ball Valve - 2 Switch Control
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
