Review on Pair of Smoke Lens Amber Front LED Turn Signal Light Assemblies for 2007-2017 Jeep Wrangler JK - Fender Flares Eyebrow Indicator Side Maker Parking Lights Bulb Included by Daniel Mettler

Easy install except I need terminators on my 2008 JKU Rubicon. Disconnect the wiring, remove the bulb from the existing turn signal and press the notch on the two tabs and slide the existing turn signal through the front of the grille. You may have to press and squeeze the tab on one second and then press for a little while while continuing to pressurize the signal. That was the easy part. Not a lot of room for wiring, but more if you turn the wheel to make room. The pull up resistor goes from the black wire to the white wire closest to the red slide on the harness. You can check that with a simple 12V tester. Turn on the turn signal you want to test and touch the wire harness on that wire and the test should cycle on and off. I mounted the terminator to the frame by drilling the small hole you see in the photo and simply screwing it on.