Review on POWERTEC 110550 Aluminum Adhesive Sanding by Abdalla Galloway

The adhesion on these discs seems to be very bad. When I received it I removed the old disc and washed the remaining adhesive off the roller with mineral spirits and then made sure the roller was dry. I put on a new disc and made sure it was pressed all the way up against the roller. After about 2 hours it came off the plate around the entire perimeter. He pushed her back but let her go again. I could also tell by tapping the disc that at one point it had gone towards the center. So I ran the heat gun over the pane to possibly loosen the adhesive. Left it overnight and seemed to be holding up. I'm not sure if this is the normal way to do it. I haven't run this yet so don't know what will happen but will update the review later.