Review on Creality 3D Ultra Flexible Removable Magnetic by David Blackstock

UPDATE: I want to change my rating of this product. I left my original review below so others who are having the same issue can understand what I saw. So the main reason for my liability issues was my switch to Revain Basics PLA. This PLA (I have several rolls) needs to be used at a much higher temperature. I have had clogging issues during use and have seen others suspect the clogging and adhesion issues are due to the low temperatures. People have suggested 230C for the finish, which is a lot more than the PLA says. I started testing at high temperature and found that PLA worked much better. With that in mind I went back to my Creality build plate and it has held up great. I then went back to my Pla hatch box and my regular 205C and it fitted in perfectly. I've increased the rating to 3 to see how it performs over the next month and if all goes well I'll increase it again. For about 10 prints this worked pretty well. Then I had liability issues. I have a BLtouch for auto-level but I've changed the z-offset up and down, higher temps, heatbed, heatbed not. The thing just doesn't work anymore. Washed with alcohol, nothing. So I'm going back to glass and glue. since then my problems with the liability of the pla are gone.