In general, when we replace incandescent bulbs with LED, the light output will be brighter. Not so with these, they are definitely darker. The color is not the typical fluorescent yellow-green, but softer, almost with a pink tinge. One of the downsides to these lamps is that the instructions were for a different type of replacement lamp so the instructions were useless. Luckily, figuring it out wasn't difficult (see below). Another downside is that it comes with a wiring harness with a connector that you have to cut off. It also doesn't include the necessary wire nuts for the modification. All in all, not a very pleasant experience, especially at $10 for a lightbulb! *** Instructions *** Turn off the power to the headlights using the switch. Remove the lamp cover and remove the old lamps. Remove the ballast cover. Find two switchable power cords for your fluorescent lights (12v only). Cut them out of the ballast when you identify them. Locate the +12V line with a voltmeter (possibly red or black). After identifying the wires, turn off the power switch. Disconnect the quick connector on the red wire of the included wiring harness and connect it to the +12V line. Use a wire nut (not included) or solder the wires together and use electrical tape or shrink tubing to insulate. Connect the negative wire (probably white or black) to the black wire and insulate it. Replace ballast cover. Connect the black harness connector to the connector on the back of the lamp. Turn on the device to make sure the connection is correct. Install light bulbs in the lamp. Please note that you can rotate the bulbs so that the light falls in the right direction. Insert the second black connector into the second bulb. Insert in holder. Check functionality. Place the clear cover back onto the bracket.
Short Stubby Antenna For Mazda Miata 2006-2022 - 3.8 Inch, Compatible With CravenSpeed
29 Review
2-Inch CravenSpeed Stubby Jr Antenna For Mini Cooper Models 2001-2022 - Compatible And Optimized For Improved Search Engine Visibility.
29 Review
Powerful 100W SoundAlert Police Air Horn Kit With 120-130 DB Bullhorn Speaker And Manual Control Or Stock Horn Bypass For Emergency Vehicles
39 Review
Upgrade Your Light Bar With NAOEVO 14AWG 240W Custom Wiring Harness And 6 Modes Light Bar Controller
29 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Gooacc 50Pcs Hood Insulation Retainer Clips - Perfect Replacement For Grand Cherokee, Dodge Ram, Chrysler PT Cruiser, Plymouth Laser, Neon - OEM Part Number: 4878883AA
33 Review