Review on πͺ W83021 Tie Rod Puller for Enhanced Performance by Gary Ferguson
The neck and tube are too narrow and flat.
Multiple sizes of inner tie rod ends. But the neck is so flat that most internal drawbars will not fit or reach the "nut" at the end of the drawbar. Used it on a small car today, it had the correct adapter but due to the design and flat neck I couldn't get it to actually lock or reach the end of the inner tie rod. The tube is very long, but the end of the adapter (neck) is so flat that it doesn't reach the side of the adapter even on small cars.
- Positive only
- Something is wrong
New products
Comments (0)
Top products in π Pullers
π§ Pro-Grade 18212 4" ADJUSTABLE 2 OR 3 JAW GEAR PULLER: Ultimate Versatility for Efficient Gear Removal
9 Review
Fully Assembled CR-V Steel 8-Inch 3-Jaw Gear Puller For Easy Removal Of Gears, Pulleys, Bearings, And Flywheels - DURATECH Gear Puller Tool
25 Review
πͺ Efficient Pitman Arm Puller: OTC (8150) Conical Design for Easy Removal
9 Review
π§ Astro Pneumatic Tool 78825 25-Piece Master Front Wheel Drive Bearing Puller Set with Grade 8 Drive Bolt
9 Review
