Review on Deepcool DA700 80 Plus Bronze Certified ATX Power Supply: Advanced Flat Cable Design for Enhanced Efficiency by Chun Hee Kim ᠌

In general, the unit seems to be good, before that there was a 550-watt chieftek system in the photo, it pulled, in principle, not bad, but when playing there were slight interference on the monitor . and I like a lot of twists and I'm going to upgrade, so I took it with a small margin) in general, I was alerted by the voltage in the same chieftek aida showed in idle time 12.096 volts (I didn’t check it in loads) I don’t remember five or three . and the dipkul stood at exactly 12.000 volts . and when the video card was loaded, it dropped to 1120220 in the photo exactly I didn’t have time to make a screen for this figure . Of course, I understand that Aida and all these programs do not give an exact result, but still, in order to have something to compare with . and the noise on the screen did not go away Well, this is a separate story) And I ask you people ) if someone buys this unit and you will have a multimeter! then check it for voltages and if it’s not particularly difficult, please answer)) how many watts are actually there . I simply don’t have it, I would check and write it myself) but in general the unit seems to be not bad, it doesn’t make noise, it doesn’t heat up, and many wrote I wouldn't say the wires are hard. In principle, they should not be soft) but if something doesn’t fold well somewhere, just twist it in the right place and that’s it) I’ll definitely write something that will change! Thank you all for your attention and I hope for your help in measuring voltage, because it’s not difficult for you, but we will all be pleased)