Review on 💡 EZDIY-FAB ARGB Memory RAM Cooler DDR Heatsink with Controller for DIY PC Game MOD DDR3 DDR4 (Compatible with ASUS Aura Sync,GIGABYTE RGB Fusion and MSI Mystic Light Sync)-Black-2 Pack: Maximize RAM Performance and Aesthetics with EZDIY-FAB ARGB Memory RAM Cooler - Sync and Control with Leading RGB Software! by Jason Yancy

Edit: Remove stars again due to poor quality control, 2 of the 4 sticks I bought have defective LEDs which are always a different color than the rest and flicker. This is kind of a mixed review but it ends with 5 stars because I ended up getting an amazing looking product for a very low price. To start I bought 2 RGB sleeves for my 2 sticks and they worked great and I was about to write a rave review. .Then I bought 2 more memory sticks and 2 more RGB caps and you can see in the photos that one of the leds was bad and didn't match the rest of the RGB caps. I asked for a replacement and one was sent to me the next day and arrived in a few days, good customer service! I installed this RGB cover and one of the LEDs was noticeably dimmer than the others (no pics) so I asked for a different replacement. On the second exchange I got a different LED that doesn't match the rest of the sticks. 3 tim That's nice, isn't it? On my third try I finally got a lid that worked great and now my computer looks like a light show! You're lucky or have the crazy experience of constantly asking for replacements until you get one that works fine. However, I ended up giving it 5 stars as the customer support was fantastic. Seriously, within an hour they sent me one, even the third time, no question. The product is very easy to install ONLY IF you have bare RAM sticks. If your bars have built-in heatsinks like mine, the installation is considerably more difficult as you have to get a hair dryer and heat the sticky glue holding the heatsinks in place and remove them. Be careful when doing this, I accidentally knocked out a small surface mount diode, luckily I had a soldering iron and I just stuck the diode in place where it should have been. Fault. With the old heatsinks removed, installation isn't difficult, literally 2 screws and they're in place.