Review on 🚗 SAN AUTO Rear Bumper Guard Protector - Anti-Collision Patch, Anti-Scrape Black Rubber - Universal Trunk Door Entry Guards for SUV/Cars - Non-Slip with Tape - 38 inch by Daniel Mandal

- Application is fine if you take your time and get it right, but it really needs more double sided tape for good adhesion. : 1.) Clean both areas of the bumper (remove all wax) and the underside of the bumper guard. 2.) Mark each end where it needs to be attached (use blue tape for easy removal). 3.) Apply double-sided tape to the bumper area (circle the entire bumper and another strip in the middle), leaving the top red plastic panel intact. 4.) Place the bumper protector over the double sided tape, being careful not to damage the red plastic. 5.) Lift one end of the red double-sided tape from the top (on the inside edge) with the protective backing on top, then slowly pull it further from the bottom. 6.) Remove one side completely (left or right) and lift the edges of the remaining top of the double sided tape with the bumper protector on top and slowly peel off the red cover at the bottom, stopping at the remaining side where You must remove the red cover on the side before fully revealing the entire length. There's no turning back; Once contact is made, it cannot be peeled off without destroying the tape.