Review on Enhance Your Creality Printer with BIGTREETECH STM32F103RET6 Motherboard Upgrade by Carlos Phillips

First of all I want to say that this board is amazing. It was really just a breadboard, all connections were the same. The problem occurred when I tried to print something. It turned on, the screen said Marlin 2.0, I did a test run and set it up automatically, everything worked fine. Then I went to print something. It heats up perfectly and then crashes into a corner without stopping, causing the extruder belt to slip. I checked all the connections again and they were ok. I chose to re-upload the firmware using Marlin 2.0.7 and everything worked fine. It was incredibly easy to flash the SD card, of course I'm quite experienced when it comes to 3D printers, but with all the YouTube videos any beginner should be able to do it. Also, I can FINALLY SLEEP QUIET. Wonderful.