Review on 🔧 High-Quality Urethane Band Saw Tires 9 inch x 1/2 inch x .095 inch 2 Pack - Compatible with Delta 28-150, Craftsman 137.21409, Grizzly G1052, and More by Luis Neels

So far I am very happy with these tires. I have used them to replace the factory tires on my 9" Ryobi band saw (BS902) and they work great. Search "replacing ryobi 901 tires" on youtube and you will find a good tutorial video. Not exactly like mine, but I used a lot of the ideas found there. This job is a lot easier if you remove the bandsaw wheels, so I highly recommend doing that first. . This made installation relatively easy and I didn't have to boil/heat it like some people have recommended. Stretch evenly: After assembly, I removed the clamp and put the screwdriver shaft completely under the tire so that it was between the tire and the rim. I then ran the screwdriver around the wheel a few times to make sure the tire was evenly tensioned around the wheel. Installing the tire: I then made sure the tires were properly seated in the grooves on the wheels. They fit TIGHT into the BS902's groove, so I rolled the wheel across the concrete floor and pushed pretty hard with my hands so the concrete pushed the tire into the groove. After installation, I reinstalled the wheels and adjusted everything. Since then it's been working great. I would definitely recommend them and would buy them again.