Review on 📺 Long Arm TV Wall Mount - Swing Out Full Motion Design for Corner Installation | Mount-It! | Fits 40-70 Inch Flat Screen TVs | 220 Lb Capacity | 26 Inch Extension by Brian Potter

Good, fairly strong for a one-hand rotating mount. a 13mm head didn't fit them. A 1/2" head works best. 3) The instructions state a MINIMUM bolt spacing of 16". The maximum allowable mounting plate spacing is 16". This turned the minimum into the maximum. I had to drill a shaft to accommodate to accommodate the 18" (old house) spacing. A 24" spacing isn't too uncommon, if your cleats are that far apart you're SOL. Two screw lengths were included to attach to my TV: 40mm and 15mm Unfortunately I needed 25mm screws. The standoffs were too long. Note that all TVs are different. I used 25mm screws on top and 40mm screws (with a couple of extra washers, not included) for those Bottom used. Despite the flaws I would buy this unit again. My TV weighs only 36lbs which is overkill for this mount but I would have preferred it (minimal/no play) I have this TV a lot slightly overrated by a "4" but considering the price it was still decent.