Review on 🔧 Efficient Upgrade: Ender V2 Motherboard Carborundum 8 6X8 6X9 8In Enhances Performance by William Pacino

I followed a great assembly video tutorial with advice. I don't know if I can put it together with a single guide, so be sure to use the video. I spent about 3 hours on the building process to make sure everything was perfect rather than trying to rush. THAT HELPED ME ALOT. I believe the negative reviews are the result of a rushed build that led to an overhaul to get it right. My calibration print went perfectly. Then I printed an articulated rabbit. I use a print height of 0.16 because everything I print is very small and needs to be as smooth as possible. After printing the bunny I found that I have to spray hairspray on the bed for some floss colors but once I do that it works great and I can leave it for a few hours overnight and the print is waiting for me, perfect in the morning. I've had it for a few weeks now and it hasn't shown any signs of problems and I've been tapping on it pretty much daily and often overnight. As soon as I move into a new house with a slightly larger room, I want at least one more of them. I didn't make any modifications but I built a small double wall styrofoam sheet barrier which I placed on the side where the drafts come in just to eliminate possible interference from what I've read about. So far I've used the supplied filament, it's been very nice and smooth, Hatchbox and Makerbot branded filament, all to great effect. TLDR: Take your time setting it up and you'll have a great typing experience. :D