Review on 🪚 Oshlun SBNF-120120: Top-Quality 12-Inch TCG Saw Blade for Aluminum & Non-Ferrous Metals by Devin Perry

Is this a joke? Is it actually called an aluminum saw blade? For which aluminum? I first cut out a piece of 2" x 4" 6061-T6 aluminum, waxed it, and it just stuck to the point where I had to stop and remove the accumulated material between the teeth. I found it a little challenging. A few days later I cut a 6063 (softer aluminum) 1/4" wall, 2" x 2" angle and after two cuts I had to keep cleaning the blade. And that's not to mention heat build up, bears, poor finish , noise, vibration and differences in cutting accuracy A monster wood blade would have done better I got pissed and installed a Diablo blade (like I had before) with the same number of teeth/configuration and everything was back to normal I had a bad blade?teeth look nice and sharp geometry looks ok i think i will try to return the ones i got as a replacement and just keep doing diablo metal cut yes its a few bucks more , but it's worth it