Recently my Ryobi Electric Pressure Washer (RY141612) would not turn on; The test/reset on the fork failed so I was pretty sure the problem was with the GFCI fork. The original connector is listed in the part number as: G1215PA2-1ElegrpClass A Rainproof GFCI15A 125VAC 60Hz 1875WD I did some research and this item is an exact replacement from the same manufacturer and cheaper than I could find anywhere else. 4 Phillips screws for opening the bottom cover 2 Phillips screws for separating the power and negative terminals 2 Phillips screws for the cable strain relief clamp. Installation in a new fork is just as easy. .Supplied with 3 rubber bushes (14AWG, 16AWG, 18AWG). Test the device according to the instructions before use. My pressure washer is working again and I hope you find it useful.
π© LSD85124 Yellow Wet Noodle and Retriever - Intelligent Labor-Saving Device
9 Review
Enhance Your Home Automation with TP-Link π KP100KIT Kasa Wi-Fi Smart Plug Slim Edition 2-Pack
8 Review
π₯ Securifi Peanut Smart Plug - Easy 1-Minute Setup & Remote Monitoring/Control of Lights and Appliances with Free iOS/Android Apps and Browser Interface - White
9 Review
Leviton 2711 Industrial Grade 30 Amp Locking Plug - NEMA L14-30P, 125/250 Volt, Grounding, Black-White
9 Review
π Robertson 2P20132 Quik-Pak: 10 Fluorescent eBallasts for 2 F40T12 Linear Lamps, Preheat Rapid Start, 120Vac, 50-60Hz, Normal Ballast Factor, NPF, Model RSW234T12120 /A (Crosses to RSW240T12120 /B)
4 Review
Wireless Electronic Ballast Interface Certified
8 Review
π‘ High-Quality Advance ICN-4P32-SC Electronic Fluorescent Ballast: Ideal for 4 Lamps, 32W T8, 120/277V
3 Review
π‘ Electronic FL Ballast ICN-4P32-N (Formerly ICN-4P32-SC) for 3-4 F32T8 F40T8 F17T8 Lamps, 120V/277V Compatibility
5 Review