Review on 🔌 Arlington LV1 10 Voltage Mounting Bracket: Easy & Secure Installation by Loren Jacobson

Amazing quality What makes these amazing: A.) High quality boxes. B.) are suitable for drywall and the hole cut can be as little as a fraction of an inch. small and you can glue them in place for a nice fit. C.) is suitable for wood wall paneling, but you will need to create a pilot hole with a 1-1/2" drill bit. and then cut out the rest of the hole. which you will need to complete this setup.) Tape measureii.) Small bubble leveliii. ) Hacksaw (I used http://www.amazon.com/Stanley-15-556-Jab -Cushion-Grip/dp/B00002X21W/)vi ) you may need a pin attachment to make the cut with a hacksaw on wood panels etc. how to install: 1.) use a reference measurement either from a corner of the wall or from an electrical outlet 2.) use a magnet or a rod finder, place it somewhere between two rods 3.) find where you put a The top of the Arlington should be the same distance from the floor as other boxes on any other wall in the house.To find this out without removing the faceplate of another box, place the faceplate on the Arlington and measure from the top edge the other box on the wall in the room up to the top of the Arlington with the front panel. Mark on the wall where the top of Arlington will be. or where the top of the bezel is, and then subtract the top of the distance from the bezel to Arlington. facing the wall, level with the bubble level and at the height required for step #3.5.) Trace the inside opening of the Arlington with a pencil or pen (I suggest a pencil so you can erase the marks if you make a mistake is made). 6 .) Using a spirit level, ensure the lines form a perfect square/rectangle. 7.) Using a hacksaw, make a cut along the outside edge of the lines you just circled. 8.) Insert the Arlington into the hole you just cut the hole if your ground floor to attic reference measurements are accurate. 9.A.) For the poles I used: Cen-Tech 65327 3/16" x 11' Fiberglass Wire Guide Kit 9.B.) For the bungee I used: Greenlee 430-500 Poly Fish Line, Tracer Green, 500 feet 9.C.) For Cat6 I used: [[ASIN:B005UFKJPG Cat6, 550MHz, UTP, 23AWG, 8C Solid Pure Copper, CMR, 1000ft, White, Bulk Ethernet10.) Pull through the wire you attached to the wall hanging, insert the Arlington and screw, but do not overtighten11.) Connect the connectors to the wire and install the faceplates.