
Installation and setup could be easier. Software support is rather haphazard. They don't provide a way to put the included operating system (Android version) back onto the module after replacing it with something else. You can't just plug it into your computer and flash it. Adding a microUSB connector and the hardware required to do so would make it MUCH EASIER and more flexible to use. Or even making a separate USB adapter that you could plug it into for flashing would be way better than the current "hot swap" and pray you don't short anything with the method they use now.

Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review

π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review

LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review

GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review

π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review

M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review

36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review

MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review