Header banner
Revain logoHome Page
Jeff Payne photo
1 Level
1294 Review
51 Karma

Review on ๐Ÿ–จ๏ธ Efficient SIQUK Extruder Printer for Makerbot and Creality Models by Jeff Payne

Revainrating 4 out of 5

Great nozzles, make sure you understand your printer.

These tips are excellent, I have an Ender3 Pro and they fit the hot end snugly, but when using the larger tips I found the heating element didn't hold up well and I had to lower the print speed and drastically increasing the temperature for PLA printing. It took a day and a half to get good quality prints. Also, the brass used in it seemed quite soft, I tried removing one while the system was still hot and the hex fitting on the outside came loose a bit. before it started spinning it might be my fault but I haven't had this problem with other brass atomizers. my own idiocy.

Pros
  • 3D printer parts and supplies
Cons
  • Socket required