Review on 🛏️ Creality Removable Flexible Magnetic Bed Plate - 235x235mm: Enhanced 3D Printing Convenience and Adhesion by Justin Early

My Ender 3's plastic mat was kind of stuck to the heated bed (not sure why as I didn't use solvents and never operated it). after 60°C) and the cleaning was very strenuous (took some bedding with him). I decided to replace it with something else, so I bought three different types of rugs. At the moment the other two are still in their boxes because this was the first one I've tried and it's phenomenally good. Installation and alignment was very easy. I did without glue stick, hairspray etc. and printed (with PLA) directly onto the bare PEI surface. The prints adhered firmly to the PEI and finished without errors. Once the bed had cooled, I was able to remove the impressions with a simple stroke of the spatula and no discoloration or smudges were visible on the PEI. Do not confuse the yellowish PEI layer (above the steel mat). for the protective film and try to remove it. The rug came with a different rubberized backing (not attached) but based on recent experience I decided not to use that and just laid the rug directly on the bed (which as the Ender 3 Pro is already magnetised). So far it is working very stable with no obvious wear or damage.