Header banner
Revain logoHome Page
Brandon Plowden photo
1 Level
1310 Review
73 Karma

Review on ๐Ÿ’ง Moisture Compression of EVacuum Printer Filament by Brandon Plowden

Revainrating 5 out of 5

Simple and holds the seal well

This kit works great. I really only needed a pump and pouch so can't speak to wet strips. In the last 2 years I've used maybe 5 full coils out of the 30+ I've accumulated. As I have a lot of used coils I thought it was time to store them better as I wanted to avoid possible dehydration. I've had PLA in my pocket for several months and it hasn't lost its seal. I've also reused the black eSun PLA roll case a few times. Even some new rolls lose their tightness in less than a month. With that in mind, I think this is a must-have accessory for all 3D printing enthusiasts.

Pros
  • Additive Manufacturing Products
Cons
  • Legacy Model