Review on In-Line ANL Fuse Holder with 🔌 150 Amp Fuse for InstallGear 4/2/0 Gauge AWG by Mike Ken

- I like that there are built in cable clamps and there is no need to crimp the clamps at the end of the cable. goes directly into the fuse holder and touches the cover slightly or when the fuse holder base is stressed or twisted due to a slightly uneven mounting surface. The lid has very small lugs that hold it in place and it would be better if it had a more secure connection. I drilled a hole in the center of the base just below the fuse and attached it with a self tapping screw. Factory installation locations are below the cable and require access to both sides of the terminal blocks to remove/install the cable for installation. Other fuse options should be specified when ordering. I am using this with 4 ga cable but I would prefer to use a less than 150A fuse for my application.