Review on HiLetgo Development Compatible Interface Arduino by Davaun Pritchard
Works great with USB Host Library 2.0
I bought 2 and they work fine. Sorry to everyone who got a defect. For Micro Pro 3.3V: 1. Disconnect the line between VBUS and 2k2 to get 5.0V2. Two jumper wires on VCC and RST, VBUS and RAW3. Place Micro Pro on USB host shield, align and connect: (top) INT, GND, (bottom) SS, MOSI, MISO, SCK, VCC, GND, RAWDone.
- Easy to read control panel
- Not bad
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
Another interesting products
π§ Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review