Review on 🔧 Elimination Threaded Spring Backlash by Twotrees by Draven Invert

Edit: Update This is good enough and better but very helpful ------------------- I put this review on hold because I really wasn't sure about the quality of. It was sent quite well with the findings between the dense foam. My box had a few creases from shipping. It could have been better delivered if they put the LEDs in some sort of structural sound tube between the foam. Both rolled well on the flat float glass for the eyes. After the installation I had some hesitation. I tried to make them as straight and parallel as possible. If it's not aligned, you'll need a dial indicator to find it. After many hours of trying, adjusting, and swapping connectors, I've almost eliminated the wobble, it's still very little. I just have to do a big print to see if it has any bad effects. I will report this later. If the lead screw is good and straight as the glass roll shows, then the brass nuts are not so good. I'll order some to see if it helps. If the nuts don't help, the rods are slightly bent, most likely due to damage in transit, which could have been avoided with slightly better packaging. I'm giving 1 star, but if the fluctuations don't affect the print quality, I've dropped it to 3 stars. If the new mother gets rid of the wobble I'll give 4 stars. Otherwise they are slightly bent, most likely due to shipping, and the quality of their use determines the star rating from 1 to 3. I will update later.