Review on 🛡️ Stern Shield by Arunprasath Corso

Stern Saver saves lives for anyone who installs a transducer on the stern of their fiberglass boat without drilling holes or screws. I recently installed a new Humminbird Helix 7 SI transducer on my boat. . The transom on my Nitro Bass boat is designed in such a way that it is difficult to mount the transducer in the traditional way. Since I don't have a jack, my only option was to mount the sensor on the flat surface of my step behind the cushion. I used two Stern Savers to mount the Transducer Shield & Saver to securely mount the Humminbird transducer. Stern Saver is easy to install if you just follow the instructions. My setup was a bit tricky as I was using two Stern Savers which required precise alignment of the pre-drilled holes for the TS&S. In addition, the horizontal mounting surface presented another challenge, fixing the whole thing in the right position with adhesive tape. The hardest part of the installation was getting the epoxy out of the applicator. Must be a bit warm. Also, don't forget to remove the small two-pin connector that is blocking the injector.