Review on 🚗 ANCO AR-12A Rear Wiper Blade - 12 Inch - Top Quality, Single Pack by Phil Prater

2011 Unfortunately ANCO does not provide written fitting instructions but the fitting was very easy. The wiper arm should lift off the glass at an angle of about 45 degrees. The plastic trim cap at the base of the wiper arm must be removed by gently prying the cap away from the wiper arm. After removing the decoration panel, the wiper arm can be lifted off the glass at an angle of 45 degrees. The wiper blade is connected to the wiper arm with a "Roc-Lock" connector. To remove the wiper blade, simply lift the wiper arm off the glass at a 45 degree angle, then rotate the wiper blade so that it is perpendicular to the wiper arm and gently pull on the old wiper blade to loosen it from the wiper arm . . To install a new AR-14A wiper blade, insert the AR-14A wiper blade into the Roc-Lock connector at a 90 degree angle to the wiper arm, and then rotate the blade so it is parallel to the wiper arm . Finally, replace the plastic pad at the base of the lever and you're done! The replacement took about 5 minutes and required no tools. ANCO has an installation video on [.]