Review on Computer chair Metta Samurai S-3.04 for executive, upholstery: textile, color: gray by Dorota Poniak (Grand ᠌

one bolt was not reported to me, but it’s good that it was intended for the armrest, and not for the bearing part, so that I could immediately mount it on the chair after assembly. The next day I went to the economic near the house, took the missing bolt 6x25 for 3, everything is ok. They put gloves to assemble the chair, but they are construction s, they might not have put them, to be honest. The armrests, in my opinion, are rather weak, but maybe this is the case for all chairs, you just can’t lean on them with the whole mass, in principle they are not intended for this. Also, as a minus, I can cancel that the characteristics of the seat height and back height are different on different sites, on the catalog the back has a height of 81 cm, somewhere they write 75, in the end it turned out to be 70, but if you count from the seat, then even 65 cm. The minimum seat height from the floor is also different everywhere, it will be correct 50, but somewhere they write 40. But it turned out to be just right for me, 183 cm tall and weighing 90 kg, but whoever has smaller legs, the gas lift height may not fit. The only thing is that the thing that should support the lower back supports the area closer to the coccyx more.