Review on 🔥 TYC 700050 Subaru Replacement Blower Assembly: Enhanced Airflow Efficiency for Optimal Performance by Jorge Toussaint

A few notes on this fan. First, many people said it takes 15 minutes. I'd agree if I've done it before, but most people will be doing it for the first time, so I'd say it's closer to half an hour. It's not difficult at all. You just have to be careful what you unscrew and don't break any of the clips holding the wiring in place. Some of them resolve immediately, while others need to be resolved. I found the swap and reassembly quick because at that point I knew what I was replacing and where everything was going. The only tricky part is getting the glove box back in place and aligning it properly. It took a few shots but I could see some struggling with that a bit. The fan is not noisy at all in my opinion, as some have reported. The fan that was there was so noisy due to blown bearings that I'm pretty happy with the volume of this replacement, if it can be called noise at all. Another point, another reviewer made a great suggestion to buy a cabin air filter and replace it at the same time. It was a great suggestion as you have a glove box at the same time. I couldn't believe (probably should, since it's been so long :) ) the dirt I was breathing in. I'm never going to let this go on for so long with so much junk that was in that compartment!