Review on 🚀 Edelbrock 2121 Intake Manifold: Unleash Optimal Performance by James Mcphearson

Not ridden yet, just installed on engine. Fits well so far, but I didn't notice until after I fitted the holes for the thermostat housing cover, THERE WERE NOT CUT OUT! The instructions say "Check all tapped holes". I've successfully wired them myself, but if you're new to this like me, make sure you follow the instructions before installing. If you don't like something, send it back. I didn't send it back because I had already installed it and threw the box and packaging in the trash. Lesson learned UPDATE 2019: I repeat, check everything! I've just noticed that when the carburetor was installed, a hole for the stud bolt wasn't drilled cleanly vertically! It leaned a little off center and I had to get creative to get the carburetor to fit properly. It's either "seconds" at Revain or Edelbrock is having quality control issues.