Header banner
Revain logoHome Page
Doug Taylor photo
Thailand, Bangkok
1 Level
718 Review
25 Karma

Review on πŸ”΄ iBrightstar Brilliant Red LED Bulbs for Tail Brake Stop Lights - Newest 9-30V Flashing Strobe Blinking Brake Lights 7440 7443 T20 with Projector Replacement by Doug Taylor

Revainrating 3 out of 5

Not CAN-compatible and slightly larger in diameter and length than a glass bulb.

These lamps are not CAN compatible. They will run cars (tested in VW, Mercedes-Benz and Toyota) with a diagnostic system to alert you to a blown bulb. If you plan to use them in a modern OBDii equipped vehicle you will also need to modify the wiring harness to include a 47 ohm 5w resistor. The diameter of the plastic lamp body is slightly larger than that of a standard glass lamp. This can cause problems on certain vehicles when installing front or rear marker lights. Be sure to check the installation of the glass bulb. You will need 1.15mm extra hole spacing to install these bulbs without modifying your car headlights.

Pros
  • Application: Flashing Strobe Light Flashing Brake The LED lights will quickly flash 3 times at the beginning of braking mode for easier and safer stopping, and then turn on a stable continuous brake light (allowable flashing time) to protect cars, trucks, SUVs, SUVs. setback.
Cons
  • Band