Review on Enhanced Connectivity: GearIT Ethernet Cable Snagless Patch for Industrial Electrical Usage by Christine Foht

So, I've been searching after the connection cables. I did the same with these. OD measurements are as expected for Category 6 cable, 5.9mm. The feeling is right and the turning pressure looks right. be real stranded copper wire. I dug up my old but very good 12MP camera and it's no better than my phone trying to get a good macro shot of the RJ45 end. terrible shots. So stick to the main images. Let's cut the end off one and pull it back. We have a center divider. Check. We have a good twist rate, around 5mm/spin. Check it well with my calibrated 24 AWG stranded wire stripper and yes it matches what was seen at the end of RJ45 stranded copper conductors. Check.Gear It uses a Category 5 RJ45 configuration (24AWG wire only), but remember that the pinout of the new Category "cat6" connectors allows for 23AWG wire, which is optional in Category 6, but is not required. IMHO, real Cat6 patch cords. The sealing at the ends looks good on all 26 of my cables. I haven't tested them all for continuity and proper wiring yet. but will do with each before they are put into use.