Review on 🖥️ Huanuo Dual Monitor Stand: Height-Adjustable, Free-Standing Two Arm Monitor Mount for 13 to 32 inch Flat Curved LCD Screens with Swivel and Tilt - Supports 17.6lbs per Arm by Douglas Jakab

cheap junk. Don't buy it. At first it was impossible to easily assemble the first two pieces until I drilled and cut holes in the post. A cheap fad where the coating was torn off if you just finger-tightened the screws into the holes. Even applying a small amount of torque caused the screws to start shedding chips. Third, after finally completing the assembly, I found that even a slight misalignment of the monitor from the center can cause the entire stand to tip over in front of me. The "leg" of the stand is too flat from front to back. If you have enough room to spread both hands almost straight left-to-right then that might be fine, but if you're trying to fit in the corner of the booth you'll need to extend the stand well away from the corner to avoid doing this tilting problem. And that with a 32-inch monitor with which the product is advertised.