Review on 🛠️ Makita 5 Pack - 4.5" Cut-Off Wheels for 4.5" Grinders - Aggressive Metal & Stainless Steel Cutting, INOX - 4-1/2" x .045" x 7/8-Inch by Glenn Cartwright

I needed to replace the fuel pump on my 2000 Chevy 4x4 Silverado 3 door. I refuse to remove the fuel tank and I refuse to remove the bed to do this job! So I measured where the pump is under the bed of the truck. I cut a 12" x 12" hole above it with perfect access to everything. (Trying to saw was a nightmare) These cut-off wheels are perfect for this and will cut through 4" x 17" metal bars with no problem to reassemble the panel I cut out. Used 24 Phillips head screws. (smoother tips) Then siliconize a small gap, couldn't have done better, I had to pre-drill all the holes as the rods are too thick and the screws could break or pry out.