I bought a 6 x 8 x 4 inch box to make an electrical junction box for a generator. I used a GreenLee puncher for duplex sockets. Durability can be an issue. Pros: Wall thickness is pretty good, measuring 3mm (just under 1/8"). Sealant is pre-loaded. Plastic lid screws hold the lid securely. Lid screws are captive. Plenty of internal screw bosses (which I haven't used) It can be messed with attached to the surface using the gussets/tabs on the lid without drilling the inside Cons: ABS construction, mainly S (styrene) content This makes it brittle I was afraid it would break on impact but it almost held up 1/2" less than stated with each measurement. The lid screws are made of plastic, which makes me doubt their durability. No information on screw sizes for the bosses or brass studs on the sides. Overall I am satisfied with the project box. It works as intended.
Protect Your Electronics With Zulkit'S Blue Metal Enclosure: DIY Project Case With Preventive Features (9.1" X 7.3" X 3.9")
13 Review
Waterproof ABS Electrical Junction Box Enclosure With IP65 Rating - Black 7.87 X 4.72 X 2.95 Inch (200 X 120 X 75Mm) By Zulkit
12 Review
Inkbirdplus Dustproof Waterproof Electrical Enclosure
9 Review
β‘οΈ RVGUARD 50 Amp Weatherproof Outdoor Electrical Power Outlet Box - Lockable RV/EV NEMA 14-50R Receptacle Panel, 125/250V, ETL Listed
9 Review
π Robertson 2P20132 Quik-Pak: 10 Fluorescent eBallasts for 2 F40T12 Linear Lamps, Preheat Rapid Start, 120Vac, 50-60Hz, Normal Ballast Factor, NPF, Model RSW234T12120 /A (Crosses to RSW240T12120 /B)
4 Review
π‘ Hydrofarm Quantum QT400 Dimmable Ballast for 400W Grow Lights
5 Review
β‘οΈ Sunpark LC-12014T (1) FC12T9 32W Circline (1) 2D 38W (1) FC16T9 40W Circline (1) FC9T9 30W Circline Lamp Compact Electronic Fluorescent Ballast with Circline Lamp Plug 120V
7 Review
Fulham WorkHorse WH2-120-C Adaptable Ballast - 2 Pack
3 Review