Review on 🚗 Enhanced Air Suspension Kit: Air Lift 1000 Series (Model: 60809) by Dontra Majmudar

I don't usually write reviews but wanted to share my positive experience. Fits perfectly on a 2014 Toyota 4Runner. First, you don't need to unscrew a single screw from this car for installation. The total assembly time was just over 1 hour and another 30 minutes for the professional assembly of the overhead line. Installation steps: 1) Lift the drill rig off the side frame until the tire is off the ground. Install a safety jack. 2) with a hacksaw or saw everything. Remove the first two rings of the gravel chopper. Cut each one individually to facilitate removal through the spring. 3) Install the air duct on the airbag. Use safety wire instead of factory clamps. This will allow the nipple to fit into the factory hole in the spring support. 4) Deflate the air bag and clamp the air line with a vise to hold the air bag in a horizontal position. Feed the other end of the air line down through the factory hole in the spring bar. 5) Press the airbag into the center of the spring with soap and water. Release the handle and the airbag inflates. Use an air compressor if necessary. Gently pull the air duct down so the airbag is snug against the bottom tab and nipple. Throw away the black spacers that came with the kit. On 4 skids they are useless. 6) Lower vehicle and repeat on other side. 7) Drag the airline along the stabilizer to the center. Install a tee and run a conduit through the factory steel cross member (allow 6 inches of clearance for axle travel) and follow the gas fill line back to the trailer connector. 8) Drill a 1/4" hole in the flat bar next to 7 for the trailer plug. Install the shader valve and you're done! See photos of my 4Runner. 2" Fox leveling coils fitted. Pneumatic pockets on the back with 20psi pressure, loaded with camping gear inside and out. (Use 2psi for normal driving)