Review on Engraving Cutting Machine 🖋️ with Rotation Attachment- Improved SEO by Adan Hudson

Not the worst accessory for your laser engraver; get ready to play around. I have a full spectrum laser and sold a non-functional rotary axis at an overpriced price. They then charge a fee for the withdrawal. This unit gets a lot better if you take responsibility and fix its little issues: - Make sure you buy the right motor configuration. The FS P series laser requires 2-phase (4-wire) motors. - You need a connector that fits your laser. For the FS P series, this is the GS16-4 aviation fork. - The laser must be adapted to the resolution of the rotation axis. 720 steps per inch seems correct. - Height adjuster clamp has been reset to avoid binding - remove, flip, insert thumbscrew in correct direction. - All screws are loosened, so align and tighten drive wheels. - Rubber feet increase unit height by 3/4 inch; it's wasted 3/4 inch. Remove the legs and replace them with felt pads. - The device was missing an O-ring, suitable for M3X63. O-Ring M3x63 Buna-N, 70A Durometer, Round, Black, 63mm ID, 69mm OD, 3mm Wide (25 pcs). Delivery from China. The block arrived in a week with no damage.