Review on 🖨 ELEGOO 0.15mm Printer Released by CHPOWER by Anthony Gupta

I used up all the packaging I received thinking I had put it on wrong. I also replaced the LCD on my printer thinking it might be the problem. It turned out that my Anycubic Photon's power supply wasn't providing enough power, so the display wasn't bright enough. According to a YouTube video to exchange, it takes about 5 minutes and a bottle cap. I used this last fep last week (about 22 hours print time) and it works fine. No bad prints caused by sticking to the FEP fiber and warped prints. Basic steps: Remove the old film. Place the bottle cap on the table. bar in the middle of fep. Poke the FEP into the screw holes to allow the frame to be reassembled. Then tighten it while the cap is still under the cap.