Review on 🌪️ CraftBot by Resistant MakerBot: Tornado Series - Enhancing Additive Manufacturing Products by Andre Belitz

Used with my Creality CR-6 SE. Level the bed with the nozzle installed. With the right Z offset, I've had constant problems with prints not sticking to the bed. When you lower the nozzle, it breaks and rolls over the PLA sphere. I raised the nozzle and obviously the grip deteriorated. I tried several dozen prints and didn't get past the skirt without problems. About half the time the PLA stuck to the side of the nozzle and knocked part of the skirt off track. The diameter of the Micro Swiss was much larger. It seemed a lot closer to 0.8mm compared to 0.8mm in the same line of brass nozzles. I really don't understand all the positive reviews, maybe I only got 1 in a million with terrible quality control. But I would definitely avoid this one.