3D One - Ultimate Car Scratch & Swirl Remover - Advanced Rubbing Compound & Finishing Polish - Achieve Flawless Paint Correction 16oz. Review

Great product. I can't give this 10 stars otherwise I would. Good product. Amazing results. Start with the cutting board while the product is not smudged, switch pads to the buffing pad and finish clean. I got 50/50 on their facebook page.

I'm usually an avid user of chemicals, but after using this hybrid compound I'm buying 3D detailing products. I made a comparison between the v36 and the 3D chemical guy: the hybrid and 3D removed almost all scratches and swirls, whereas the v36 didn't even come close. Do your car a favor and use this product. for the second run.

Okay I've never attempted a paint repair but my car was shipped out and arrived with scratches from loose belts which have put my car out of service for 2500 miles. My car looked terrible. Enter 3D One and Torque 10FX from the Chem guys. I started with the medium cut orange cog and went around the whole machine. I left the 3D on the machine and switched to a black hex that was finished last and lubricated with a final pass chemical lube for the second pass. I was surprised. The hurricanes are…

That's pretty amazing. I typically use this in one step with a one step MF Lakeside pad or a Meguiars microfiber finish pad and get amazing results. The ability to remove defects and surfaces is very impressive. Not as hard as the ACA 500 but definitely up there. The processing of this material is also a pleasure due to the very long processing time and the absence of dust. Can also be used in direct sunlight. For the price and features, everyone should try it. I just needed to add more to this

Not suitable for a perfect finish. Suitable for polishing, but not for cutting. You can get a good finish on anything but black. My experience tells me that the product cuts paint well when it's thick. This stuff is like water so as expected it didn't fully fix the color as advertised. I sanded and then polished. I changed the RPM on my flexible DA and hand speed, I changed as many things as possible and couldn't get a flawless finish. So I pulled out something with a top that contained a…

I used this for a one step fix and the car looked better than new with Uro-Fiber 50/50. On the second car I just did a 2 step touch up with t 3D One with Uro-Fiber 50/50 followed by a Black Buff and the results have exceeded my expectations! Originally I was going to just do one step with Uro-Fiber and finish with lighter pressure as it has worked well before, but I figured what the heck could it be too. With a little more time and effort I was blown away. There was very little dust and it was…

My transition to polishing in one step. Pair it with the right pad and technique and it takes care of minor imperfections without burning through much clear coat. Easy to remove, no dust, long run time (cycle time or whatever you want to call it). I've used it in direct sunlight in 90+ degree heat and humidity and was able to get the job done. Pictured was a 2019 Mustang 5.0 with the usual factory imperfections (scuffing, rotation marks, braids) and dealer installed imperfections (twisting and…

My honest opinion. The product is easy to work with and stays moist for a long time. That's good because you don't have to keep adding food and there's no dust. What did you do on the new car panel? Put a few dots on the foam pad, spread it over the entire slab, reapply the product and buff the slab. After that I would switch to a finishing pad and do the same thing, applying the product, spreading it over the board and then reapplying. The best thing about this product for me was that it…