High Performance K&N Cold Air Intake Kit: Guaranteed Horsepower Boost: Compatible with 2005-2019 Toyota Tacoma, 2.7L L4, 63-9026 Review

Installation was easy. But unfortunately my 2016 Toyota Tacoma 2.7L lacked more power. I was hoping for more power, but all I got was a lot more noise.

Great upgrade but unfortunately my engine ran rough and was clogging the MAF sensor. It would be nice if you didn't have a mas. Air flow meter on the engine. I still recommend this product.

is definitely worth the money pretty easy to install. The difference in performance and sound is noticeable, but only under hard acceleration. more importantly, it makes normal everyday driving enjoyable. just step on the pedal lightly and off you go. Love it.

Not worth the money, it's super loud. It can rattle on an airbox as it's just hose going through everything in a double sided box. Discontinued but it still knocks and makes noise when starting or idling. Very disappointed in the quality and effort K&N put into this kit. Wouldn't recommend it.

Installed on my 2009 Tacoma 2.7L. Installation took just under 2 hours, everything was pretty easy. I added 2 clamps to the hose that connects the back of the intake manifold to the top of the engine. Everything else was taken care of. Gives the engine a nice growl when you sit on it. I will report on performance and consumption when I drive it at least 1000 km.

I installed this product on my 2012 2.7 liter Tacoma 4x4 m/ta a few days ago and felt a little more boost. My truck is really lagging behind due to its lift and mud tires, so every little extra horsepower helps. Took about an hour to install, 4 pints of beer and dope, would have been quicker to install but the instructions were pretty steep but other than that it's a good product. There's a nice rumble as you knead the pedal and you can hear it sucking in that air. Took me about 3 days to get…

This was my first attempt at installing an air intake myself. The instructions weren't very helpful (they don't tell you which screws or washers to use and there are many different sizes to choose from). Through trial and error, choosing the right screws and washers, I finished the build in about 5 hours. I couldn't be happier with this product. There is a noticeable increase in power at high rpm and it sounds great when you hit the gas! To my surprise, my car's fuel economy also improved…

Shipping to Guam in 5 days! This is impressive considering the size of the box. I have a 2010 Tacoma Access 2.7L 4cyl 4x2. Installing the intake manifold took about 90 minutes (with little knowledge of car and truck engines). After installing K&N 63-9026 I noticed an increase of about 2-3 mpg as long as I keep the RPM as low as possible at 2000. The sound is really raspy and loud with my Hookers Max Flow muffler, but sometimes the rumble in the cockpit can get a bit too loud when I'm going…

My Tacoma has a 4 cylinder engine and while it has enough power for my use, this system added quite a bit of power and torque and sounds great too. The gas performance improvement is a bit better, but I don't drive on the highway very often, but I'm sure that this system will improve the situation when driving on the highway. Don't try it yourself if you're not doing anything. automotive work. This can be a little tricky and will void your warranty. It takes about an hour for experienced…