🔌 ACDelco GM Original Equipment PT2782 Multipurpose Pigtail in Black Review

The wires are larger than the factory wires and the butt joint won't work with the factory wires so use a smaller butt joint and you'll be fine. Work for 94 Oldsmobile Regency 98

Perfect replacement for the camshaft sensor connector on a 2005 Silverado 5.3L truck. Always use genuine ACDelco parts on GM vehicles. Highly recommended.

Delco Excellent OEM part in original sealed Delco factory packaging. I used it to replace a faulty crankshaft sensor. The only thing is that the three wires are NOT color coded, so you have to pay attention to the wires on the original connector.

2000 Chevy Blazer LT 4.3 2WD- Used to replace the crankshaft position sensor connector. Perfectly connected with the included wrapped rear headers. Tested and working. Highly recommended. Thick wires are used as OEM.

Like most new GM products. They should be more like old fittings in terms of water resistance. They got water in too easily. It is better to go back to the 86-91 Lesabre design. Otherwise with waterproof Posi locks. They are very easy to install.

I'm a GM technician and thought I needed to buy a seat belt for my Lesabre, but I refused to pay $200 for a seat belt. Found the part number on the oreily website. The required $40 per part is less than $20 here and comes with free shipping! This is an aDelco part and it fits perfectly. Solder it to my wire harness and plug it straight into my Directional.2

I bought this pigtail (PT2782) to replace the original crankshaft position sensor pigtail on my 1999 GMC K1500 Suburban (GMT400 body, L31 Vortec 350 V8) to replace. The kit includes a three-prong connector with three wires cut 16.5 inches from the back of the connector to the end of the wire (I measured this, it may vary slightly, but it's more than enough to snip off damaged wires) . and there is still a lot to put together). It also comes with three crimp and heat shrink butt connectors (I…