🏍️ Amazicha Black Reflectors for Harley Street Glide Electra Glide Road Glide Road King Latch Covers Saddlebags Side Visibility 2014-2021 Review

They look good on my 2018 Road King. The double sided tape doesn't stick edge to edge which is why they buckle. You can try trimming the tape so you get it on the edges and then in the middle.

Deceived. I ordered (4) new reflectors and only received (2) adhesive strips. Reflectors have light scratches. I'm adding them to my new trip so it's important that they look used.

Didn't fit so I filed a bite, then filed some more, then some more and after a while it looked awful. It was deflected about 1/4 inch. Too much for one file. They end up in the trash! I'm not sure if it's a reflector or my hard bag. This is the 2018 Street Glide Factory hard case. Moral of the story, don't grind, just send it back.

When removing the old red reflectors I used Goop Off to loosen the adhesive and then used a small screwdriver to pry it off the latch. I cleaned the latch assembly so I had a clean surface for the new reflectors. It wasn't a bad job, it took a long time to get Goop Off working, but it was worth the wait. It looked great!

The perfect replacement for the red reflectors on the 2020 Road Glide Special. The fit was perfect and they look great. The only thing I could see that could be a problem is that the included 3M tape doesn't reach the end of the reflectors. Once they feel connected, they feel secure, but there is room for improvement in this area. Otherwise 10/10!

Overall a good quality product and the reflector itself is an exact replacement. But my problem is they don't give you enough double sided tape to cover the full length of the reflector so the corners want to go up! If it wasn't for that, I would have given this product 5 stars. If you buy these you should definitely buy some good double sided tape and cut it to fit the entire reflector.

I have a 2009 Vulcan 900 with "Harley" hard shells. They are perfect for her. I love these reflectors, they are very easy to install and fit perfectly. The only problem I see is that I might have to buy 3m of double sided tape and eventually redo it simply because the parts they give don't fit. the edges are perfect. If they made the tape exactly the size of the reflectors that would be great, but the edges are a bit ready to pop out a little and they'll probably get worse over time. To fix…