🔩 Anndason Stepper Mounting Bracket Screw Kit Review

I used one of these as a replacement bracket for my 3D printer and it offers much more stability than the original bracket. The only complaint I have is that the included screws were too long for my stepper, but the included nuts acted as spacers, although it would have been nice if the short set was a bit shorter. It would also be nice if someone made them with motor mount slots to make alignment easier to fine tune, but since I couldn't find anything like that I just had to get by.

Needed a bracket to mount the extruder stepper motor at a 90 degree angle to allow use of a larger lead screw. I know I could print one of these, but my printer is broken so it's not working. it works for this purpose and holds up very well. The only problem is that the existing screw mounts for the original position of the stepper motor are too far apart to use the rails cut into the mount. All in all a powerful kit that comes in a pack of six. Does the job and looks great on an all black car.

These brackets are well made and tested as a square with my locksmith square. My only complaint is with the included hardware: the kit includes four M3 10mm countersunk screws for mounting the motor, both of which have the wrong head (the holes are NOT recessed) and are too long for a standard NEMA17 motor frame; You have to deal with 2mm extra length. Obtain a pack of 25 (or more) M3 8mm dome, button, button-head, button-head or socket head cap screws (NOT oval, countersunk/flat, etc.) to…