🌀 ANVISION 40mm x 10mm DC 5V USB Brushless Cooling Fan, Dual Ball Bearing, Improved YDM4010B05 Review

This fan is significantly quieter than the standard fan on my A350 PSU. I printed a modified backplane and this fan fits perfectly. Just make sure the pin wires match the correct points on the connector. I had to swap the red and black wires in the included 2 pin connector to get the power to work.

installed on standard ender 3 hot end box. just fits well. had to be soldered into the wiring harness. it is slightly quieter than the standard hotend fan. However, this decline comes at a cost. the sound is higher and generally more disturbing. So I'm trying to get on with it as quickly as possible.

I needed a tiny fan for my paludarium to keep condensation off the front glass without causing too much climate change. It's perfect! Fits comfortably in a small corner and works like a charm. Very satisfied as there is just enough wind for my 30" x 18" tank. My plants love it and so do I

Recording outdoor video here in Florida can take a toll on your camcorder since it's summer almost the whole year. But with some of these fans, I can control the temperature of my camera and charge it with a USB power bank.

Bought to cool some network equipment. Got the fan via Prime very quickly and it works great with the USB port on the front of my Lenovo ThinkCenter Tiny. However, it is loud, too loud for use in the living room. It has a whiny sound, worse than most laptop fans at full speed.

Ordered a replacement fan which failed after a few years in the VCR/Security Recorder. The fan is "always on" and all other devices in the room are OFF. You can hear this guy humming! It obviously makes noise because it WORKS and pulls out enough air for its size. Benefits: Moves air through the recorder, cooling it down. strength for its size. Fair price, not flashy so I didn't expect it to be super quiet. Cons: Too bad it's not quieter. ?Rating: If I could test EVERY fan in this category I…

Excellent fan and drives a lot of air. A bit noisy for the size, but that doesn't bother me. Although the one I got didn't have a ball bearing on the badge, I looked up the part number and it really is a double ball bearing fan. Great fan.

noctua. I measured the decibels of this fan compared to the stock Ender 3 fan and found it to be about 5 decibels quieter on average (measured at 1 inch and 1 meter). All in all, a good buy if your stock Ender 3 fan broke and you want to buy this - something a little quieter, with the same airflow, and replace it outright. I also bought a 40mm Orion fan, which is also 24V and much quieter than the Anivision fan, although it has a smaller CFM, uses different screws and doesn't have a 2-pin…