Auto Ventshade [AVS] Low Profile Ventvisor / Rain Guards Matte Black, 4 Pc 774011 Fits 2009 - 2014 Ford F-150 SuperCrew, 2011 - 2014 SVT Raptor SuperCrew Review

Save your money and move forward. I read all the reviews, good and bad, as well as those that talked of the "Ford auto window" problems. I read reviews where this problems has been addressed and fixed.I don't think so!I have used this manufacture for window vents as well as bug shield deflectors for years and have always been pleased in the past. But as for the current, not so pleased. Directions are easy to follow, pretty quick n easy straight forward installation.clean the surface being…

I ordered this product because it was about $20 cheaper than my local Advance Auto Parts. First off, the shipping was a little slow, but with the $20 savings that wasn't too big of a deal. Now to the product, very easy to install. You pull the backing off of the adhesive strips, apply to the window channel, push in a clip, and roll your windows up. Keep your windows up for at least a day to let the adhesive grab on. Now comes the frustrating part: the window of the 2009-current F150 will bump…

On my 2002 Explorer I had the ventshade model that stuck to the outside of the door frame. They came off after several years, then the strips were a MAJOR pain to clean off. This model slides inside the window track and the adhesive strips hold them there. They are a snug fit, it takes some bending of the ventshade to get it into position. My set of these included a plastic "clip" that is designed to press the front end towards the outside of the door frame. These clips interfere with my…

I really do like the look of these vent-visors. I'm used to the larger, more extended ones (the normal size, I guess), but these low-profile ones were just as easy to install and look really clean on my truck, which is black, so they blend in well and almost look like they came from the factory.Downside:The front-driver-side visor is not the correct curve to match the door's window-gasket. It's a small amount too curved, but only noticeable to the keen eye. That, and the fact that they were…

UPDATE:After about a month, I no longer have any problems with my windows. They all go up without a glitch.Fit in the channel with no problem on my 2014 F150. Only problem I’ve had is I had to take out the channel spacers because my windows wouldn’t go up. Because my truck has the automatic up windows on the front, the passenger side window would keep going back down. I would have to wait until the window got almost to the top, then stop it and slowly put the window up the rest of the way. This

Still had issues with window going up in auto. Remember if replacing older "in-channel” shades remove ALL adhesive from before. Mine had adhesive the full length so I’m anxious to see how these work with just 4 tabs with thin strips of tape work. I beveled the end of the small plastic pieces to remove all abrupt edges.

Not all vent shades are created equal and while these are a little pricey, they are worth it. Box came smooshed to no fault of the shade or Best Buy, delivered by UPS. Shades are otherwise undamaged. 3M tape was mint along with alcohol preps for cleaning as well as instructions.I will say theses are "low profile". On the front shades there is a "clip" which is just an extention of the shade, not an actual clip. It fits between the rubber of the inside of the door and the plastic

To install, you clean (as you should) peel the tape then you have to add shims to the inside of your window trac. This, will peel the tinting off your window if you have tinting installed. Just be warned.

Easy to install. Just be sure you have it where you want it before adhering it to the vehicle the adhesive is so good where you stick it is where it stays.

These units fit my Ford truck perfectly an I installed the complete set front and rear in.less than 30 minutes. They look great too!.

loved them ,, works great , just take your time and dont rush ,, wish they had some sort of guide to rest on or something so you dont get them on crooked ,, but awsome product so far

On the rear windows of a 2011 F-150 the shape of the visor would not allow a flush fit to the vehicle. Maybe I got a bum copy. Your experience may vary. The front pieces were fine.

Happy with my purchaseeasy instructions how to apply. Just put them on so don't know how durable the glue will last - but expect a long time.they were a bit narrower than I had imagined - but okay and didn't want to bother sending back to get wider ones.Seem well made and will do the job they were designed for.would recommend this product

make sure they are level before sticking, i messed up the first time but it still looks ok. these work great! Thanks for attention!